Setup - Roland KD-120 Owner's Manual

Setup

Assembling the KD-120
1.
Place the KD-120 pad, with the head surface facing downward, on a flat surface such as the
floor.
2.
Use the included drum key to loosen and remove the bolts for the brackets on the back of
the KD-120 pad.
3.
Mount the stand on the brackets so that the output jack for the KD-120 pad faces up.
Use the bolts you removed earlier to secure the KD-120 pad to the stand, tightening the
bolts with the included drum key.
* Take care not to pinch your fingers between the KD-120 pad and the stand plate.
4.
Adjust the ends of the legs to match the location where you're installing the KD-120.
Adjust to use the spike legs when installing on carpeting or other soft surfaces, or the
rubber legs when installing on flooring or other hard surfaces.
When shipped from the factory, the stand is adjusted for using the rubber legs. If you're
using the rubber legs, proceed to step 5 on the next page.
Switching to the spike leg
1.
Slightly loosen the foot bolt.
2.
Move the rubber foot all the way upward, and then tighten
the bolt.
The spike will protrude from the rubber foot.
* The tip of the spike is sharp. Handle it with care.
* When using on flooring, the spike may damage the floor.
Change to the rubber foot.
Switching to the rubber leg
1.
Slightly loosen the foot bolt.
2.
Move the rubber foot all the way downward, and then tighten
the bolt.
Bracket
Output jack
Bolt
Rubber foot
Spike
Bolt
Rubber foot
5