Roland KD-120 Owner's Manual page 6

5.
Loosen the T-bolts for the stand and mount the legs on the stand.
Install the legs as shown in the figure so that the ends of the legs protrude by about 2 cm.
6.
Tighten the T-bolts to secure the legs to the stand.
7.
Lift the KD-120 and place the stand and the four legs upright.
8.
Adjust the angle of the head surface so that it's at a right angle to the floor.
Use the included drum key to loosen the bracket bolts you tightened in step 3, and adjust
the angle of the KD-120 pad so that the head surface is at a right angle to the floor.
9.
Install the included beater on your kick pedal.
* Using a beater made of felt may result in wear to the felt. Use the special included beater or a plastic beater
as the beater for the kick pedal.
10.
Mount the kick pedal on the KD-120.
* With certain kick pedals, the chain (or belt) may come into contact with the hoop surrounding the KD-120's
pad. If this occurs, adjust the angle of the KD-120's pad to prevent such contact. Keep the adjustment within
a range that does not allow the KD-120's pad hoop to touch the plate of the stand.
Prevent contact
between the
hoop and plate.
11.
Make any fine adjustments necessary and tighten the stand brackets to make sure the KD-
120 is secure on the stand.
Make sure the KD-120's four legs and heel portion of the kick pedal is securely on the floor
by loosening the stand's T-bolts and adjusting the length of the legs.
* If the kick pedal has no under-plate, then arrange the stand's plate section at a right angle to the floor.
12.
Adjust the striking point for the beater.
Normally the beater's striking point is adjusted to fall at the center of the head.
Adjust the striking point so that it doesn't extend beyond the cushion on the back of the
head. Moving the striking point closer to the sensor increases the sensitivity, so carry out
fine adjustment to suit your preferences.
6
T-bolt
90˚
If the kick pedal has no under-plate, then arrange
the stand's plate section at a right angle to the floor.
Extend the leg by about 2 cm.
Allow sufficient
clearance
here.