Pch Ssata Configuration - Gigabyte R180-F34 Service Manual

When SATA Type is set to IDE

PCH sSATA Configuration

sSATA Controller(s)
Enable/Disable sSATA controller.
Options available: Enabled/Disabled. Default setting is Enabled.
Configure sSATA as
Coonfigure on chip SATA type.
IDE Mode: When set to IDE, the SATA controller disables its RAID and AHCI functions and runs in the
IDE emulation mode. This is not allowed to access RAID setup utility.
RAID Mode: When set to RAID, the SATA controllerenables both its RAID and AHCI functions. You will
be allows access the RAID setup utility at boot time.
ACHI Mode: When set to AHCI,the SATA controller enables its AHCI functionality. Then the RAID
function is disabled and cannot be access the RAID setup utility at boot time.
Options available: IDE/RAID/ACHI/Disabled. Default setting is ACHI.
SATA Test Mode
Enable/Disable SATA Test Mode.
Options available: Enabled/Disabled. Default setting is Disabled.
SATA Mode options
Press [Enter] for configuration of advanced items.
Support Aggressive Link Power Mana
Enable PCH to aggressively enter link power state.
Options available: Enabled/Disabled. Default setting is Enabled.
Only Supported When HDD is in AHCI or RAID Mode.
(Note)
BIOS Setup
(Note)
(Note)
- 87 -