Installing A Memory; Dimm Population Table - Gigabyte R180-F34 Service Manual

2-5-2 Installing a Memory

Before installing a memory module, make sure to turn off the computer and unplug the power
cord from the power outlet to prevent damage to the memory module.
Be sure to install DDR4 DIMMs on this motherboard.
Follow these instructions to install the Memory:
1. Insert the DIMM memory module vertically into the DIMM slot, and push it down.
2. Close the plastic clip at both edges of the DIMM slots to lock the DIMM module.
3. Reverse the installation steps when you want to remove the DIMM module.

2-5-3 DIMM Population Table

When only one DIMM is used, it must be populated in memory slot0 first.
Memory populated sequence must be followed with slot0/slot1/slot2.
System will not boot normally with incorrect populated sequence.
Hardware Installation
Slot Per Channel (SPC) and DIMM Per Channel (DPC)
Ranks Per
Type DIMM and
Data Width
1 Slot Per Channel
SRx4
RDIMM
SRx8
RDIMM
DRx8
RDIMM
DRx4
RDIMM
QRx4
LRDIMM
1
2
2
Speed (MT/s);
2 Slot Per Channel
1DPC 1DPC
2133 2133
2133 2133
2133 2133
2133 2133
2133 2133
- 21 -
2DPC
1866
1866
1866
1866
2133