Advertisement
Installing the LED
6.
Using the tape measure, measure and mark the
inside of the upper steering column cover.
7.
While wearing eye protection, lightly center-
punch the mark, and drill a 5.5 mm hole through
the center-punched mark. Remove all burrs.
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
5.5 mm
DRILL BIT
UPPER STEERING
COLUMN COVER
65 mm
CENTER OF THE
UPPER STEERING
COLUMN COVER
8.
Route the terminal ends of the LED through the
hole you just drilled, and secure the LED with the
push nut. Install the push nut securely.
UPPER STEERING
COLUMN COVER
PUSH
NUT
2-PIN
CONNECTOR
2-PIN
CONNECTOR
9.
Locate the 2-pin connector included in the kit.
Firmly push the LED terminals into the 2-pin
connector until they click into position, then lower
the lock.
10. Install the bracket onto the security unit.
AII 25460 (0310)
LED
WHITE
WIRE
RED
WIRE
BRACKET
SECURITY UNIT
CONNECTOR
Do not push on
the connector.
PUSH
NUT
3 of 5
Advertisement
