Yunca Gas EIB Operations, Maintenance & Warranty Information page 13

6. With firebox empty a vacuum cleaner can be used to remove any visible dust and lint from within
the firebox area.
7. Replace logs in the reverse order of removal.
8. Replace the bark tray and redistribute the bark.
9. Replace and relatch the front door and close the side panels.
Fan assembly removal
Booster fan assembly Electronic (IR93) is not designed to be dismantled.
6. Disconnect the wires from the Thermostat behind the Right Hand side panel. This is achieved by
removing the back panel control cover. Easing the back cover of the Thermostat box up to allow
access to the electrical connections.
7. Lifting the Fan Box assemblies clear of the attachment screws ensuring the wires come freely from
the appliance.
8. The fan can be replaced or cleaned. Cleaning should be completed with out disassembly.
NOTE: The fan assembly should only be disassembled by an electrician or trained
Yunca Technician.
9. The process is reversed for installation and the fans operation is tested.
16-02-05 Page 13 of 19
IMPORTANT.
Unplug the fan from the power supply.
1. Remove the four screws that retain
the louver
2. hearth.
3. Remove the Thermostat Sensing
Bulb from the Saddled on the Fan Back
Plate before removing the Fan Back
Plate.
4. Disconnect the Earth Wires at the
bottom of the Fan.
5. Unplug the electrical connection at
the back of the electronic control box.
Operation Instructions for Electronic InBuilt EIB 2002