Yunca Gas EIB Operations, Maintenance & Warranty Information page 11

Fig 8 Hand Control
Fan speed is increased by pressing on the + sign of fan button and reduced by pressing on the – sign
of the fan button.
Pressing Off delayed will initiate a 30-minute timer delay off. This can be cancelled by re-pressing
the Off delay button.
Turning on your YUNCA ELECTRONIC INBUILT
1. Turn the Gas and Power supply on.
2. Adjust the thermostat to above the sensed temperature to allow the fire to light.
3. Press the On / Off button once. Neon on the hearth will light up to indicate the control is active.
Note Neon will remain on to indicate unit is active. There may not be any flames as the thermostat may
be set below the temperature it is sensing. If going on holiday make sure light is off.
4. The burners will light at the previous setting and fan speed.
5. Adjust the Flame height button as required to achieve the required heat out put.
6. Adjust Fan speed button to achieve the optimum speed.
Turning off no time delay.
1. Press On / Off button once. Note the Neon will be off to indicate the fire is turned off. The
power supply can be turned off.
Turning off with time delay.
2. Press Off delayed button once.
3. The Neon light will flash to indicate the timer delay activated.
4. When the 30 minutes is up the fire will shut down.
5. The restart, follow the to start procedure.
The time delay can be over ridden by following the Turning off no time delay.
16-02-05
Direct the infrared beam from this hand control to the receiver mounted
behing the hearth. The receiver will "light up" when receiving a signal
from the hand control.
The Hand control operates on 4 AAA size alkaline batteries. Remove the
battery cover on the back of the hand control to insert batteries paying
attention to the polarity
Note multiple pushes of a button may cause a lock out in the electronics. If
this happens turn the power supply off and restart the Gas fire.
Pressing the On / Off button once will initiate the lighting sequence. The
Receiver will light up. The lighting sequence will take approximately 30
seconds and a faint clicking maybe heard as sparking takes place.
Pressing the On / Off button a second time will turn off the fire.
Flame height (heat output) is increased by pressing on the + sign of flame
button and reduced by pressing the – sign of the flame button.
Page 11 of 19 Operation Instructions for Electronic InBuilt EIB 2002