Panasonic KX-UTG 300B User Manual page 28

To use speed dials, go off-hook with your phone. Enter #, followed by the speed dial number (ex. #02) to
connect to the assigned phone number. If the speed dial number is lower than 10, you must enter the 0
preceding the number to create a two-digit number. If you are using a softphone, dial #, followed by the
speed dial number, and then press the dial button.
NOTE: In this guide off-hook is used to describe when a phone is in use or has a dial tone before
a call is made. On-hook describes when a phone is idle.
From the Web Configuration Utility
1. Enable the Web Configuration Utility and obtain the IP address of the phone. Select the Menu
softkey, and then select Settings and press #534 on the keypad to enable embedded web. Next,
select the Menu softkey again, and then select Settings and locate Information Display to locate
your phones IP Address.
2. Enter the IP address of the phone into the address bar of a web browser (Internet Explorer,
Firefox, Chrome, etc.)(Figure 4-1).
Figure 4-1: Navigate to the Phone's IP Address
28 | P a g e
© Nextiva, All Rights Reserved