Periodic Inspection - xCraft XPLUSONE Operating And Maintenance Manual

7.4.2 Periodic Inspection

Performed every 10 flight hours
More detailed than Preflight Inspection
1. Spin each motor by hand and check that the motors spin smoothly and quietly
2. Inspect airframe for damage.
3. If there is evidence of damage under a cover remove that cover and inspect the components
underneath
4. Remove propellers and perform the control check found on page 26
5. Check the rigidity between the top pylon and the wing
6. Hold the wing in one hand and keep it stationary
7. Hold the top pylon with your other hand
8. Apply light pressure to the pylon and verify that it does not flex more than a few degrees in any
direction
9. Repeat steps a-c on the bottom pylon
10. Remove both pylons
11. Inspect wires that go between the pylons and the wing
12. Check the wire insulation for any exposed wire
13. Check connectors, verify that connections are not loose
14. Check landing gear
15. Hold one of the pylons in one hand
16. Grasp the landing gear with the other hand
17. Verify that landing gear is firmly attached
18. Repeats steps a-c with the other pylon
19. Reinstall both pylons
20. Reinstall propellers
21. Perform a preflight inspection found on page 24
Platinum only:
22. Connect X PlusOne to mission planner
23. Connect battery and check battery voltage displayed
24. Disconnect the battery and measure its voltage with a volt meter
25. Verify that the measured value is within ±0.1 V of the value displayed in mission planner
v.1.1 Pg. 25