Download Print this page

xCraft XPlusOne Quick Start Manual

Hide thumbs Also See for XPlusOne:

Download this manual See also: Operation & Maintenance Manual

Quick Start Guide

www.xcraft.io

Page 2 X PlusOne Quick Start Guide Installing Pylons: 1. Connect the pylon wires to the wires in the top of the wing as shown below. Connect two bullet connectors and single ESC wire. Ensure bullet connector polarity is correct. Caution: Ensure wire polarity is correct or damage will result. Connect red pylon wire to red wing wire and black pylon wire to black wing wire.
Page 3 3. Tighten the spinner by holding the motor stationary and rotating the spinner with a thin metal rod, such as a small screwdriver, inserted into the hole in the top of the spinner and rotating the spinner clockwise. Ensure a spinners are tightened securely. counterclockwise propeller spinner...
Page 4 Install Payload: 1. For the standard nosecone, install it as shown in the image below using the supplied hardware 2. For all other payload options, follow the instructions included with the payload Controls: aileron rudder (roll) (yaw) throttle elevator (pitch) Switches: Hover (RC Only) Forward Flight (RC Only)
Page 5 First Flight: 1. Perform preflight inspection WARNING: CG outside of acceptable range can lead to unsafe flying characteristics. It is very important to check CG before each flight 2. Put X PlusOne on flat, level surface 3. Power on transmitter (All switches need to be in the ‘up’ position) 4.