Non-Serviceable Components; Replacing Components - xCraft XPLUSONE Operating And Maintenance Manual

7.3.2 Non-Serviceable Components

There are several components of the X PlusOne that are not individually replaceable. These parts can be
found in the wing assembly (main wing foam, wing spars, battery compartment, and spar insert) and the
pylon assembly (main pylon foam, and pylon spars).
To replace these components:
1. If the component to be replace is in the wing, remove both pylons and set them aside
2. If the component is in a pylon, remove that pylon and set the other pylon and wing aside
3. Remove the cover (either wing cover or pylon cover) by removing the screws holding it in place
and sliding the cover off
4. Remove all electronics from damaged assembly
5. Make careful note of all connections to the removed components as well as wire routing
throughout the assembly
6. Unscrew motor mount(s) from spars and foam and remove motor mount(s)
7. Install motor mount into new wing or pylon assembly
8. Install electronics into new wing or pylon assembly
9. Check that all connections and wire routes are installed properly
10. Reinstall the cover
11. Reinstall the pylon(s)

7.3.3 Replacing Components

1. If the component to be replace is in the wing, remove both pylons and set them aside
If the component is in a pylon, remove that pylon and set the other pylon and wing aside
2. Remove the cover (either wing cover or pylon cover) by removing the screws holding it in place
and sliding the cover off
3. Replace damaged component
4. Reinstall the cover
5. Reinstall the pylon(s)
v.1.1
TIP: You may want to take several pictures after removing the cover to
aid in reassembly
TIP: You may want to take several pictures after removing the cover to
aid in reassembly
a. If the cover is damaged, simply replace it and reassemble your X PlusOne
a. For electrical components, make careful note of all connections to that component as
well as wire routing and make sure to reconnect all connections and run all wires as they
were before
b. For motors or motor mounts, remove the screws holding the motor mount to the spars
and the screws holding the mount to the wing or pylon foam
Reinstall the motor mount and reconnect the motor wires to the speed control (making
sure to reconnect the wires as they were before)
Pg. 23