Page 2
X PlusOne Quick Start Guide 1. Install Pylons: 1. Connect the pylon wires to the wires in the top of the wing as shown below. Connect two Caution: Ensure wire polarity is correct or damage will result. Verify that all colored wires on wing match with the corresponding colored wires on pylon.
2. Install Propellers: 1. Place the bottom half of the spinner onto the motor then set the propeller over it. 2. Attach the clockwise spinning propellers (R) onto the top and bottom pylon motors and the counterclockwise spinning propellers (no R) onto the wing motors. Ensure writing is facing up. 3.
3. Install Payload: 1. For the standard nosecone, install as shown in the image below using the supplied hardware: long screws, washers, and nuts. 2. For all other payload options, follow the instructions included with the payload. nuts washers Long screws 4.
5. Controls: Forward Rotate Rotate Right Left Right Left Down Back Power switch Switch 2 Switch 4 (no function) (no function) Switch 3 Switch 1 Up – Hover Up – Fly Middle – Smart Down - Home ...
First Flight: Perform preflight inspection. 1. Place X PlusOne on flat, level surface with the GPS antenna side facing you. 2. Check that the pylons are properly installed onto the wing 3. Check for loose parts or wires 4.
Page 7
In the instance of a low battery warning, land the aircraft at a safe location. 13. Familiarize yourself with how the X PlusOne responds to control inputs. TIP: It is suggested that you do not attempt to transition to forward flight until you are...