3Com 1000 User Manual page 59

Rising Action none / event / disable port /
disable port/notify / blip / blip port/notify Use this
field to specify the action for the alarm to take
when it reaches the rising threshold:
none — no action takes place
event — an SNMP trap is generated
disable port— the port is disabled
disable port/notify — the port is disabled and an
SNMP trap is generated
blip — the broadcast and multicast traffic on the
port is blocked for five seconds
blip port/notify — the broadcast and multicast
traffic on the port is blocked for five seconds,
and an SNMP trap is generated
If user defined is displayed in the Rising Action field,
an unrecognized action has been specified using a
MIB browser. You cannot select this option.
Falling Action none / event / enable /
event + enable Use this field to specify the action
for the alarm to take when it reaches the falling
threshold:
none — no action takes place
event — an SNMP trap is generated
enable — the port is enabled
event + enable — the port is enabled and an
SNMP trap is generated
Setting Up the Switch Ports
If user defined is displayed in the Rising Action field,
an unrecognized action has been specified using a
MIB browser. You cannot select this option.
You should be aware of the following points when
using Broadcast Storm Control:
The Switch takes 5–7 seconds to recognize that a
broadcast storm is occurring.
Broadcast Storm Control calculates the average
broadcast bandwidth over the previous
20-second interval. The average is based on four
samples taken at 5-second intervals.
When the average value exceeds the rising
threshold value, the rising action is triggered.
The action is not triggered again until the aver-
age broadcast bandwidth falls below the falling
threshold level.
4-15