Technibel CAFP 124 R Technical Data & Service Manual page 133

G
Settings mode 2
<Operating procedure>
(1) Press and hold the
ously for 4 seconds or longer.
(2) Use the temperature setting
code. The item codes and setting data are shown in the table below.
(3) Use the timer time
To confirm the changed setting data, press the
(At this time, "Setting" stops blinking and remains lit.)
(4) During this mode, "Setting" is displayed, blinking. The display shows the
set outdoor unit address "System XX-YY" (System XX = System
address, YY = Address at outdoor unit sub-bus), item code number (DN
value in the table below), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes between the first 3 digits (Fig.
digits (Fig. ). When the first 3 digits are displayed, the top point of the colon is lit.)
B
(5) To end the setting mode, press the
button, button, and
and buttons to change the item
and buttons to change the setting data.
button. The display returns to the normal display mode.
A Display of first 3 digits
(5)
(1) (3)
80: <Refrigerant type> A and B are displayed alternately. (Example shows 000 410 (R410A).)
button simultane-
button.
(5)
Display of last 3 digits
B
(2)
5 - 9
(2)
(1) (3)
) and the last 3
A
5