Fujitsu scansnap sv600 Operation Manual page 159

How to Load Documents (For S1100)
Load documents in the ScanSnap in the following procedure.
For details about documents that can be loaded, refer to
(page 154).
ATTENTION
You can only load one document at a time in the ScanSnap.
1.
Open the feed guide of the ScanSnap.
HINT
l If you want the document to be ejected from the front of the ScanSnap or when there is not
enough space where the document exits the ScanSnap, open the output guide.
For details about documents that can be scanned with the output guide open, refer to
"Documents for Scanning (For S1100)" (page
l How the document is ejected differs as below depending on whether the output guide is open
or closed.
- With the output guide closed
- With the output guide open
a The [Scan/Stop] button flashes in blue. The button returns to being lit normally when
document scanning is enabled.
In addition, the ScanSnap Manager icon in the Dock changes from
Feed Guide
Output Guide
159
How to Load Documents (For S1100)
"Documents for Scanning (For S1100)"
154).
to .