Conditions For Documents To Scan (For S1100) - Fujitsu scansnap sv600 Operation Manual

Hide thumbs Also See for scansnap sv600:
Table of Contents

Advertisement

Conditions for Documents to Scan (For S1100)

S1100
Eject method
With the output guide closed
Document type
Office paper, postcards, business cards
Plastic cards conforming to the ISO7810 ID-1 type (54 ×
86 mm)
Paper weight
52.3 to 209.3 g/m
l Plastic cards
0.76 mm (0.03 in.) (embossed cards can be used)
Paper size
Width: 25.4 to 216 mm (1 to 8.5 in.)
Length: 25.4 to 360 mm (1 to 14.17 in.)
l For long page (*1)
216 × 863 mm (8.5 × 34 in.)
*1: Scanning starts when you hold down the [Scan/Stop] button on the ScanSnap for 3 seconds or
longer.
ATTENTION
l The following types of documents must not be scanned:
-
Documents attached with the metals such as paper clips or staples that can damage the inside
of the ScanSnap
Remove the metals for scanning.
-
Documents on which the ink is still wet
Wait until the ink dries completely to scan these documents.
-
Documents smaller than width 216 mm (8.5 in.), length 863 mm (34 in.)
-
Documents other than paper such as fabric, metal foil and OHP film
l When you scan picture postcards, be aware that the picture side may get damaged. It is the
responsibility of the customer to scan picture postcards.
l Be careful of the following when you scan plastic cards:
-
Cards that are bent may not be fed properly.
-
If the surface of the card is dirty with grease marks such as fingerprints, perform scanning after
wiping the dirt off.
-
Insert the plastic card straight into the feeding section of the ScanSnap. Do not tilt the plastic
card when you insert it because the plastic card may not be fed properly.
-
When you scan plastic cards with strong luster, some parts of the image may appear lighter or
darker than the original.
Example: gold colored credit card
-
Insert embossed cards in landscape orientation to achieve better scanning results.
-
If the embossed characters are not coated in gold or silver and the background color of the card
and the color of the embossed characters are similar, it may be difficult for the ScanSnap to
recognize embossed characters.
In which case, performing the following may result in an improvement.
1. Click the [Option] button in the [Scanning] tab of the
a The [Scanning mode option] window appears.
2
(14 to 56.1 lb)
155
Documents for Scanning (For S1100)
With the output guide open
Office paper
2
52.3 to 80 g/m
(14 to 20 lb)
"ScanSnap Setup Window" (page
44).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scansnap sv600

Table of Contents