Table of Contents
Advertisement
Appendix F: Configure Port Forwarding Manually
Important: Some ISPs block access to port 80. Be sure to check with your ISP so that you
can open the appropriate ports accordingly. If your ISP does not pass traffic on port 80,
you will need to change the port the camera uses from 80 to something else, such as 8080.
Not all routers are the same, so refer to your user manual for specific instructions on how
to open ports.
Enter valid ports in the Virtual Server section of your router. Please make sure to check
the box on this line to enable settings. Then the device can be access from WAN by the
router's WAN IP Address.
By now, you have finished your entire PC configuration for this device.
80
Advertisement
Table of Contents
