Display Assembly - HP Pavilion x360 Convertible Maintenance And Service Manual

Display assembly

The display is only spared at the subcomponent level. The full hinge-up is not spared.
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the top cover (see
5. Remove the system board (see
To remove the display assembly:
1. Remove the six Phillips PM2.5×4.0 screws (1) and the Phillips PM2.0×2.5 screw (2) that secures the
display assembly to the computer.
CAUTION:
assembly can result in damage to the display assembly and other computer components.
2. Pull the display into the computer to remove hinges from computer (3).
3. Separate the display assembly from the computer (4).
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display enclosure:
Top cover on page
System board on page
Support the display assembly when removing the screws. Failure to support the display
29).
43).
Component replacement procedures 55