Maintenance And Cleaning; Canceling The Programme; Cleaning The Detergent Drawer; Cleaning The Loading Door And The Drum - Beko WMY 51222 PTYB3 User Manual

4.16 Canceling the programme

To cancel the programme, turn the Programme
Selection knob to select another programme. Previous
programme will be canceled. End / Cancel light will
flash continuously to notify that the programme has
been canceled.
Your machine will end the programme when you turn
the Programme Selection knob; however, it does not
drain the water inside. When you select and start a
new programme, the newly selected programme will
start depending on the step the previous programme
was canceled in. For example, it may take in additional
water or continue to wash with the water inside.
C
Depending on the step where the programme
was canceled in, you may have to put detergent
and softener again for the programme you have
selected anew.
4.17 Your machine is equipped with a
"Standby Mode"
In case of not starting any programme or waiting
without making any other operation when the
machine is turned on by On/Off button and while it is
in selection step or if no other operation is performed
approximately 2 minutes after the programme you
selected has come to an end, your machine will
automatically switch to energy saving mode. Display
brightness will decrease. In case of rotating the
Programme Selection knob or pressing any button,
lights will restore to their previous condition. This is
not a fault.
16 / EN

5 Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular intervals.

5.1 Cleaning the detergent drawer

Clean the detergent drawer at regular intervals (every
4-5 washing cycles) as shown below in order to
prevent accumulation of powder detergent in time.
Lift the rear part of the siphon to remove it as
illustrated.
C
If more than normal amount of water and
softener mixture starts to gather in the softener
compartment, clean the siphon.
2 Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning.
3 After cleaning, replace the siphon back to its seating
and push its front section downwards to make sure
that the locking tab engages.

5.2 Cleaning the loading door and the drum

For products with drum cleaning programme, please
see Operating the product - Programmes.
For products without drum cleaning, follow the below
steps to clean the drum:
Select Additional Water or Extra Rinse auxiliary
functions. Use a Cottons programme without
pre-wash. Set the temperature to the level
recommended on the drum cleaning agent which
can be provided from authorized services. Apply
this procedure without any laundry in the product.
Before starting the programme, put 1 pouch of special
drum cleaning agent (if the special agent could not be
supplied, put max. 100 g of powder anti-limescale) into
the main wash detergent compartment (compartment
no. "2"). If the anti-limescale is in tablet form, put only
one tablet into the main wash compartment no. "2".
Dry the inside of the bellow with a clean piece of cloth
after the programme has come to an end.
C
Repeat Drum Cleaning process in every 2 months.
Use an anti-limescale suitable for the washing
machines.
Washing Machine / User's Manual