Rear Panel; Audio Out - HIKVISION DS-6600HFHI (/L) Series Quick Operation Manual

Quick Operation Guide of DS-6600HFHI (/L) Series HD Audio/Video Encoder
Item
PWR
LINK
1
Rx/Tx
HD-SDI IN
2
HD-SDI OUT
3 YPbPr Interface
4 HDMI Interface
5 OPT Interface
6 VGA Interface
Note: Each of the HD-SDI, HDMI, VGA, OPT and YPbPr video input interfaces must be connected
independently.

Rear Panel

Interface
1 RESET
2 AUDIO IN
3 LINE IN
4

AUDIO OUT

5 LAN
6 RS-232
RS-485
7
ALARM IN
ALARM OUT
8 12V DC
9 GND
Power LED indicator: 1. Lights in red when the device is working; 2. Does not
light when the device is powered off.
LINK LED indicator: 1. Normally lights in green when the network connection
is functioning properly; 2. Does not light when the network connection is
abnormal.
Rx/Tx LED indicator: 1. Does not light when the network is not connected; 2.
Blinks in green when the data is transmitting / receiving; 3. Blinks at higher
frequency when the data for transmitting / receiving is larger.
HD-SDI video input.
HD-SDI video loop output.
YPbPr video input.
HDMI video input.
OPT video input. Connect to camera with fiber optic interface.
VGA video input.
Restore the factory default settings by holding the RESET button for 15 seconds
after power is turned on.
BNC connectors for audio input.
3.5mm two-way audio interface for connection to active pick-up, microphone,
etc.
3.5mm audio output interface for connection to audio output device, e.g.,
loudspeaker, etc.
10 M/100 M/1000 Mbps self-adaptive UTP Ethernet interface.
Serial interface for configuration of device's parameters or used as transparent
channel.
RS-485 serial interface for connection to pan/tilt unit, speed dome, etc.
Relay alarm input.
Relay alarm output.
12V DC power supply
Grounding
3
Description
Connection