Checking And Replacing Fuses - Toyota 2004 Matrix Owner's Manual

carownersmanual.net
carownersmanual.net

Checking and replacing fuses

Type A
Type B
Type C
278
Good Blown
If
components do not work, check the
fuses. If any of the fuses are blown,
they must be replaced.
Good Blown See "Fuse locations" on page 252 in Sec-
tion 7−1 for locations of the fuses.
Turn the ignition switch and inoperative
component off. Pull a suspected fuse
straight out and check it.
Determine which fuse may be causing the
problem. The lid of the fuse box shows
the name of the circuit for each fuse. See
page 295 in Section 8 of this manual for
Good Blown
the functions controlled by each circuit.
'04 MATRIX_U (L/O 0307)
the headlights or other electrical
Type A fuses can be pulled out by using
the pull−out tool. The location of the pull−
out tool is shown in the illustration.
If you are not sure whether the fuse has
blown, try replacing the suspected fuse
with one that you know is good.
If the fuse has blown, push a new fuse
into the clip.
Only install a fuse with the amperage rat-
ing designated on the fuse box lid.
If you do not have a spare fuse, in an
emergency you can pull out the "INV" or
"P/POINT" fuse, which may be dispens-
able for normal driving, and use it if its
amperage rating is the same.
If you cannot use one of the same amper-
age, use one that is lower, but as close
as possible to the rating. If the amperage
is lower than that specified, the fuse
might blow out again but this does not
indicate anything wrong. Be sure to get
the correct fuse as soon as possible and
return the substitute to its original clip.
It is a good idea to purchase a set of
spare fuses and keep them in your ve-
hicle for emergencies.
2004 MATRIX from Oct. '03 Prod. (OM12861U)