Toyota 2004 Matrix Owner's Manual page 133

carownersmanual.net
carownersmanual.net
Alternate Frequency
To turn the AF mode on, push and hold
the "AM/FM" button until you hear a beep.
"AF ON" will appear on the display.
When reception condition worsen, the au-
dio system will select the RDS station
which has the same PI (Program Identifi-
cation) code.
To turn the AF mode off, push and hold
the "AM/FM" button again until you hear
a beep. "AF OFF" will appear on the dis-
play.
BAL/FADE (Sound balance adjustment
function)
This button is used to adjust the sound
balance between the front and rear, and
the right and left speakers.
For front/rear adjustment, push the "BAL/
FADE" button repeatedly until "FAD" ap-
pears
"TUNE/SELECT" knob to adjust the front/
rear balance.
For left/right adjustment, push the "BAL/
FADE" button repeatedly until "BAL" ap-
pears
"TUNE/SELECT" knob to adjust the left/
right balance.
on the display. Then turn the
on the display. Then turn the
'04 MATRIX_U (L/O 0307)
To return to the middle position balances,
push and hold the "BAL/FADE" button for
two seconds.
CD/AUX (Compact Disc/Auxiliary)
Push the "CD/AUX" button to switch from
radio to compact disc operation. A disc
must already be loaded in the player.
Error codes
If the player malfunctions, your audio sys-
tem will display the following error mes-
sages.
"CHECK CD":
D
The road is too rough. The disc should
play when the road is smoother.
D
The disc is dirty, scratched, wet or
upside down.
D
The air is very humid. If so, wait about
an hour and try again.
If the disc is not playing correctly, for any
other reason, try a known good compact
disc.
"PLAYER ERROR": There is trouble in-
side the system. Eject the disc. Set the
disc again.
If malfunction is not rectified, take your
vehicle to your Toyota dealer.
EQ (Equalizer)
Your audio system can store five different
EQ settings so that you will not need to
readjust it every time you listen to a dif-
ferent program.
To use a preset setting:
Push the "EQ" button repeatedly until the
EQ number you want to use appears on
the display.
To change a preset EQ setting:
1. Use the "TONE" button and
"TUNE/SELECT" knob to select
desired equalization. (For details, see
"TONE".)
2. Push and hold the "EQ" button until
"SELECT EQ #" appears on the dis-
play.
3. Push the "EQ" button repeatedly or
turn the "TUNE/SELECT" knob to select
the desired preset EQ number.
4. Push and hold the "EQ" button until
"EQ SAVED" appears on the display
and you hear a beep. This EQ setting
is saved to that number.
HR/MIN (Hours/minutes adjustment)
These buttons are used to adjust the
clock time. (For details, see "Clock" on
page 154 in Section 1−10.)
2004 MATRIX from Oct. '03 Prod. (OM12861U)
the
the
115