Operation - Washtech M2 Operator's Manual

M2 Machine Operation
Turn machine on at wall. Fit scrap tray, filter, upstand and shut door.
Press On/Off Key for 3 Seconds
Start key glows white as machine fills. If door is open then the start key glows
purple
Once full, rinse heating starts. Start key glows orange while heating.
Machine can be started when machine is heating. NOTE: If rinse temperature
is not sufficient cycle countdown will stop at 22 seconds. Washing continues
until rinse reaches temperature required for sanitization and countdown then
resumes.
Start key glows green when machine is fully heated. For different cycles press
the UP and DOWN arrows: Light, Medium, Heavy, Manual or Drain.
Close door/Press start key to start cycle. When manual cycle is selected
machine will continue washing until START button is pressed. Rinsing and
draining follow washing to complete cycle.
Start key glows red during cycle. Pressing Start key again terminates cycle
without rinse. Timer counts down to double zero and flashes 00 at cycle end
until door is opened.
SHUT DOWN - EVERY NIGHT
Press UP or DOWN keys to select Drain cycle. Remove drain upstand and shut
the door. Press START key to start Drain cycle. Machine drains for 100 seconds
with a cleaning rinse mid-cycle. When Draining is complete machine goes into
Standby mode. Remove upstand, filter basket and scrap tray; rinse clean and
replace.
The machine must be drained and cleaned at the end of each day.
Drain the machine as per the shut down instructions.
Regularly check the wash and rinse jets and clean if necessary.
Regular servicing of the dishwasher is essential for high
performance, efficient operation and long machine life.
Contact us for information on a maintenance programs.
Service 1 800 622 216
Parts
DAILY CLEANING
Remove, clean and replace filters.
MAINTENANCE
1 800 337 963