Keypad Operation - Washtech UL Operator's Manual

Keypad Operation

Turn machine on at wall, Fit wash filter,
scrap tray, filter basket and shut door.
Press On/Off Key for 3 Seconds
Start key glows white as machine fills. If
door is open then the start key glows
purple
Once full, rinse heating starts. Start key
glows orange while heating.
Machine can be started when machine
is heating. NOTE: If rinse temperature
is not sufficient cycle countdown will
stop at 22 seconds.. Washing continues
until rinse reaches temperature required
for sanitization and countdown then
resumes.
Start key glows green when machine is
fully heated. For different cycles press
the UP and DOWN arrows: Light,
Medium, Heavy, Manual or Drain.
Close door, press start key to start cycle.
When manual cycle is selected machine
will continue washing until START button
is pressed. Rinsing and draining follow
washing to complete cycle.
Start key glows red during cycle.
Pressing Start key again terminates cycle
without rinse. Timer counts down to
double zero and flashes 00 at cycle end
until door is opened.
SHUT DOWN - EVERY NIGHT
Press UP or DOWN keys to select Drain
cycle. Shut the door. Press START key to
start Drain cycle. Machine drains for 100
seconds with a cleaning rinse
mid-cycle. When Draining is complete
machine goes into Standby mode. Re-
move filter basket, scrap tray and wash
filter; rinse clean and replace.
Service 1 800 622 216
Parts 1 800 337 963
Operating Pro
PRE-RINSING
Pre-scraping of dishes is required
best method is to pre-rinse with w
Pre-rinse Unit - or alternatively by
Cutlery should be pre-soaked in w
cutlery pre-soak compound - refe
RACKING PROCEDURES
Do not overload racks or cutlery c
of crockery. Wash cutlery unsorte
Cycle times are short and water co
there is no advantage in overloadi
CYCLE TIMES
The UL has a 1, 2, 3 minute cycle.
CHEMICAL
Correct type and quantity of deter
Use good quality chemicals and re
the use of drying agent and cutler
chemical supplier. Detergent conc
adjusting dispensing time on the k
Programming). Rinse Fluid is facto
will take many cycles to prime. Th
adjusting screw on the front cove
DRYING
Single tank commercial dishwashe
However, the machines do rinse at
promotes fast drying particularly w
At the end of the cycle promptly r
machine - leave the rack on the be
emptying. This time will be reduce
agent (rinse fluid) which reduces w
water to drain quickly from wash w
and injectors refer to your chemic