Advertisement
Advertisement
Related Manuals for Washtech GM
Summary of Contents for Washtech GM
- Page 1 Operator Manual...
-
Page 2: Table Of Contents
High performance passthrough Dishwasher - Operator Manual Service 1 800 622 216 Parts 1 800 337 963 Distributed in Australia by Moffat Pty Limited 740 Springvale Road, Mulgrave, Victoria Tel 09 9518 3888 Fax 03 9518 3818 2 GM - Operator Manual 141218... -
Page 3: Safety Instructions
High performance passthrough Dishwasher - Operator Manual Power Cord Replacement • If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard 3 GM - Operator Manual 141218... -
Page 4: Installation Checklist
If machine doesn’t fill after switching on power, check & ensure that hot water supply tap is open, water supply pressure is not below specification and DCV is correctly installed as per arrow on DCV body. 4 GM - Operator Manual 141218... -
Page 5: Installation Diagram
GM Installation Diagram GM INST 24-11-14 3C 5 GM - Operator Manual 141218... -
Page 6: Keypad Operation
Start key glows green when machine is CYCLE TIMES fully heated. For different cycles press the UP and DOWN arrows: Light, The GM has a 1, 2, 3 minute and ma Medium, Heavy, Manual or Drain. Close door, press start key to start cycle. CHEMICAL... - Page 7 ocedures Care DAILY CLEANING It is essential that the machine is drained and cleaned at the end of by Food Hygiene Regulations. The each day. Drain the machine as per the shut down instructions. warm water with a Fisher Remove, clean and replace filters. Regularly check the wash and y scraping or dunking in water.
-
Page 8: Troubleshooting
Check flow rate of water supply Check water supply Drain Failure Drain hose jammed/blocked Check/unblock drain hose Drain upstand not removed Remove upstand before draining If the error message remains call for service 8 GM - Operator Manual 141218... - Page 9 Pre-rinse, change wash water regularly Not drying Poor wash/rinse performance Refer above Low temperatures Check heating systems Drying agent not used Use quality drying agent/rinse fluid Foaming Wash Excessive Rinse Fluid Adjust Rinse Fluid 9 GM - Operator Manual 141218...
-
Page 10: Wiring Diagram
GM7 Wiring Diagram 060247 19/12/14 3D GM7(W) WIRING DIAGRAM 10 GM - Operator Manual 141218... - Page 11 Accessories Code Description 0428001 Cuprack 450mm 0428002 Dishrack 450mm C660503 G Cutlery Container 11 GM - Operator Manual 141218...
- Page 12 ISO9001 quality management system, covering design, manufacture and final inspection, ensuring consistent high quality at all times. In line with policy to continually develop and improve its products, Washtech Ltd reserves the right to change specifications and design without prior notice.