Installing cylinder head cover
Insert reamed bolt (arrow), BMW No. 11 1 980,
•
into inner front hole.
Press centering pin, BMW No. 00 5 500, into
•
mount under the third camshaft bearing.
Install the cylinder head cover gasket with the
•
half-moon cutouts first. The marks at the front
and rear of the gasket and the cylinder head cov-
er must coincide.
Oil the gasket and half-moons lightly.
•
Press in the half-moon on the gearbox side first.
•
Apply a small amount of 3-Bond 1209 to the joint
•
area of the cylinder head and timing case cover.
Attach the cylinder head cover with gasket.
•
Downloaded from
www.Manualslib.com
11 1 990
manuals search engine
Insert all retaining screws as far as possible.
•
Tighten the retaining screws in a crosswise pat-
•
tern, working from the inside outwards.
X
Tightening torque:
Cylinder head cover ....................................... 8 Nm
Take out the reamed and centering screw and in-
•
sert the remaining retaining screws.
LT110720
LT110730
11.49