Installing piston with conrod
Turn the corresponding crankpin to bottom dead
•
centre.
The piston ring gaps must be offset by app. 120°
•
in each case.
L
Note:
The gap of the micro-chamfer ring in groove 2 is de-
termined by the pin.
Oil the piston rings, piston skirt and cylinder wall
•
thoroughly.
Downloaded from
www.Manualslib.com
manuals search engine
11 2 925
Using tensioning strap, BMW No. 11 2 925, com-
•
press the piston rings.
Insert the piston with conrod into the cylinder.
•
Drive the piston carefully into the cylinder with a
•
hammer handle.
The arrow on the piston crown must point to-
•
wards the timing end of the engine (cyl. 1).
Make sure that the pistons are in the same
•
weight category.
LT110590
LT110600
11.39