Inquiry Commands; Basic Format; Cable Specifications - Panasonic PT-AE1000E Operating Instructions Manual

Hide thumbs Also See for PT-AE1000E:
Table of Contents

Advertisement

Technical Information

Inquiry commands

Command
Control contents
QPW
Power status
QFZ
FREEZE status
QIN
Input signal status
QOT
SLEEP status
PICTURE MODE
QPM
status
QSH
SHUTTER status
QWM
WAVEFORM status

Basic format

STX
Command
Start byte
(02h)
The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds
before sending the command.
If sending multiple commands, check that a response has been received from the projector for one command
before sending the next command.
When a command which does not require parameters to be sent, the colon (:) is not required.
If an incorrect command is sent from the personal computer, the ER401 command will be sent from the
projector to the personal computer.

Cable specifications

(When connected to a a personal computer)
Projector
48 - E
NGLISH
000 = OFF
0 = OFF
Parameter: (page 23)
VID = VIDEO IN
RG1 = PC IN
YUV = COMPONENT IN
0 = OFF
5 = 180 min. 6 = 210 min. 7 = 240 min. (page 25)
Parameter: (page 25)
NAT = COLOUR1
DYN = DYNAMIC
CN2 = CINEMA2
VID = COLOUR2
0 = OFF
Parameter: (page 24)
0 = OFF
1 = FULL SCAN (Y)
2 = FULL SCAN (R)
3 = FULL SCAN (G)
4 = FULL SCAN (B)
:
Parameter
1 byte
3 bytes
1 byte -
4 bytes
NC
NC
NC
NC
Parameter
001 = ON
1 = ON
SVD = S-VIDEO IN
HD1 = HDMI1 IN
HD2 = HDMI2 IN
SCT = SCART IN
1 = 60 min.
2 = 90 min.
NOR = NORMAL
CN1 = CINEMA1
CN3 = CINEMA3
1 = ON
5 = SINGLE LINE SCAN (Y)
6 = SINGLE LINE SCAN (R)
7 = SINGLE LINE SCAN (G)
8 = SINGLE LINE SCAN (B)
The data streaming from the computer will
ETX
start with STX, and proceed to Command,
Parameter and end with ETX. You can
End
add the required parameter.
(03h)
NC
NC
NC
NC
3 = 120 min. 4 = 150 min.
PC (DTE)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents