Resetting The Lamp Runtime - Panasonic PT-AE1000E Operating Instructions Manual

Hide thumbs Also See for PT-AE1000E:
Table of Contents

Advertisement

Removing and replacing the lamp unit
1. Use a Phillips screw driver to loosen the 3 lamp unit fixing
screws until the screws turn freely.
2. Hold the handle of the lamp unit and release the lamp unit
lock.
3. Pull out the lamp unit gently from the projector.
4. Replace the new lamp unit while making sure that the
direction of insertion is correct.
Press the top of the lamp unit and make sure the unit is
installed securely.
5. Tighten the lamp unit fixing screws securely with a Phillips
screwdriver.
Attaching the top cover
1. Attach the hinge parts of the top cover to the projector and press slightly
until it clicks
2. Hook the tabs of the top cover to the projector and lift down slowly.
3. Press the back corner of the top cover gently until it clicks.
NOTE:
Be sure to install the lamp unit and the top cover of the projector securely. If they are
not securely installed, it may cause the protection circuit to operate so that the power
cannot be turned on.
Grip the handle and keep the lamp unit paralleled when you remove the lamp unit.
Some parts of the lamp unit are sharpened and may cause injury.
Do not switch the power on while the top cover is opened.
When the projector is mounted in the ceiling, keep the lamp unit paralleled and
remove.

Resetting the LAMP RUNTIME

If the lamp usage time has passed 2 000 hours (when LAMP POWER has been set to NORMAL), the projector will
switch to standby mode after approximately 10 minutes of operation. The resetting procedure should thus be
completed within 10 minutes.
1.
Connect the Mains lead to the projector and a
mains socket, and switch the MAIN POWER on.
2.
Switch the POWER button.
3.
Press the MENU button to display the menu.
4.
Press F G to select OPTION and press ENTER.
5.
Press F G to select LAMP RUNTIME.
SLEEP
ALTITUDE
LAMP POWER
LAMP RUNTIME
FUNCTION BUTTON
6.
7.
8.
9.
OFF
LOW
NORMAL
1820H
Care and Replacement
Lamp unit
fixing screws
Lamp unit lock
Press here
Press and hold the ENTER button for
approximately 3 seconds.
The confirmation screen will be displayed and
select OK.
Switch off the POWER to reset the duration of the
LAMP RUNTIME.
Confirm the duration of time in LAMP RUNTIME is
reset to "0".
Press here
E
- 43
NGLISH

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents