Table of Contents
Advertisement
Software Installation
8
Click Next when the "Upgrade Device Driver Wizard" window appears.
9
When asked "What do you want the wizard to do?" select the radio button "Display a
list of the known drivers for this device to that I can choose a specific driver." Then
click Next.
10
Select "Have Disk" for the "Select Network Adapter" screen.
11
Click Browse from the "Install from Disk" dialog box and use the "Locate File" dialog
box to navigate to <CD-ROM>\Software\LAN\DLink\W2K.
12
Select the file named "netdlh5x.inf" and click Open.
13
Click OK from the "Install from Disk" dialog box.
14
Select "D-Link DFE-550TX FAST Ethernet 10/100 Adapter" from the "Select
Network Adapter" screen of the "Upgrade Device Driver Wizard."
15
Click Finish when the Upgrade Device Driver Wizard informs you that the software
installation is complete.
16
Click Close to return to the "Device Manager" window.
Your D-Link DFE-550TX FAST Ethernet 10/100 Adapter should be functioning
properly. If it is not, restart your server.
Installing the VIA 4-IN-1 driver
Install this driver only after you have successfully installed the Windows Service Pack 1.
Install the VIA 4-IN-1 driver using the following procedures.
1
With the Magnia 510D Software and Documentation CD-ROM in the CD-ROM drive,
navigate to <CD-ROM>\Software\MAINBOARD\VIA 4-IN-1.
2
Double click Setup.exe. Follow the on-screen instructions.
3
Restart your server.
NOTE: You can set up the Ultra DMA to improve system performance. If IDE hard
disk drives are installed on your server, specify Ultra DMA using the following
procedure: (1) Install the VIA 4-IN-1 driver. (2) Click the Windows 2000 Start menu,
then Settings, and then choose Control Panel. (3) Double-click System, select
Hardware and then Device Manager. (4) Select Primary and Secondary IDE
channels in the IDE ATA/ATAPI Controller options, click Advanced Settings, and set
the Transfer mode to DMA.
Installing Windows 2000 Server
97
Advertisement
Table of Contents
