Table of Contents
Advertisement
SS38 Direct Vent Gas Stove
Before you begin — This unit is supplied with six ceramic fiber logs. Do not handle these logs
with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After
handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation of this
heater. Sooting and other problems may result if the logs are not properly and
firmly positioned in the appliance. Never add additional logs or embellishments
such as pine cones or vermiculite to the heater. Only use the logs supplied
with the unit.
Failure to position the parts in accordance with diagrams below or to use only
parts specifically approved for this heater may result in property damage or
personal injury.
INSTALLING LOGS AND ROCK WOOL
(EMBER MATERIAL) IN FIREBOx
1. Carefully remove logs from wrapping.
2. Open front door of firebox.
3. Place rear log against back of firebox. Figure 32
24
Left Base Log
Figure 33 -
Install Left Base Log
LG736
LG735
LG735
4. Place left base log on two pins
VS38 log 1
against left side of firebox.
Figure 33
FINAL INSTALLATION
Rear Log
Figure 32 -
Install Rear Log
46D0232
Advertisement
Table of Contents
