Table of Contents
Advertisement
SS38 Direct Vent Gas Stove
1. Check gas type. The gas supply must be the same as
stated on the appliance's rating decal. If the gas supply
is different from the stove, STOP! Do not install the
appliance. Contact your dealer immediately.
2. To ease installation, a 30" (mm) flex line with manual
shut-off valve has been provided with on this appliance.
Install and attach 1/2" gas line onto shut-off valve.
3. After completing gas line connection, purge air
from gas line and test all gas joints from the gas
meter to the stove for leaks. Use a soap and water
solution or a gas sniffer.
4. To adjust flame height, turn HI/LO knob to HI to get
maximum pressure to burner. Turn HI/LO knob to
LO to get minimum pressure.
5. To check gas pressures at valve, turn captured
screw counter clockwise 2 or 3 turns and then place
tubing to pressure gauge over test point. Turn unit
to high. Figure 29. After taking pressure reading,
be sure and turn captured screw clockwise firmly
to reseal. Do not over torque. Check test points for
gas leaks with a soap and water solution.
INSTALLING LOUVERS
Attach the top louver unit (two louvers
and two louver brackets) to stove with
four (4) screws provided — two (2) on
each side. Figure 30. Repeat for bottom
louver unit.
22
Pressure
Test "IN"
Pressure
Test "OUT"
HI/LO Knob
Pilot Adjustment Screw
Louver Bracket
Louver
Bracket
Louvers
Figure 30 -
Installing Louvers
STOVE INSTALLATION
Figure 29 -
Gas Pressure Check at Gas Valve
FP1979
Do not use open flame to check for gas
Millivolt gas valve
leaks.
Screws
ST1113
install louvers
FP1979
ST1113
46D0232
Advertisement
Table of Contents
