Csvf30 / Vfcs30 Log Placement - Monessen Hearth VFCS30DNV Installation & Operating Manual

!
The positioning of the logs is critical to the safe and
clean operation of this heater. Sooting and other
problems may result if the logs are not properly
and firmly positioned in the appliance. Never add
additional logs or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only use the
logs supplied with the unit.
Failure to position the parts in accordance with
diagrams below or to use only parts specifically
approved for this heater may result in property
damage or personal injury.
Before you begin — This unit is supplied with four ceramic
fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from
ceramic fibers. After handling the logs, wash your hands
gently with soap and water to remove any traces of fibers.
Log Placement - CSVF30 / VFCS30 - Figure 14
1. Install back log (#1) on rear log support bracket.
2. Install left bottom log (#2) on left log support bracket in
front of back log.
3. Install right bottom log (#3) on right log support bracket in
front of back log.
4. Install top left log (#4) on top of left bottom log.
5. Install top right log (#5) on top of right bottom log.
3-90-58D6002
WARNING
Monessen • Concorde VF Installation Manual_R11 • 02/17
!
During initial operation of the new heater, burning
logs will give off a paper burning smell and orange
flames will be present. Simply open the windows for
a few hours to vent the odor.
Right Top Log #5
Top Left Log #4
Left Bottom Log #2
Left Log Support
Bracket
RE
M O
TE
CO
N TR
O L
PI LO
Figure 14 - Place Logs on Grate - CSVF30/VFSC30
LG937
CSVF30 log place
Unvented Cast Iron Gas Stoves
CAUTION
Right Bottom Log #3
Back Log #1
Rear Log
Support Bracket
T
O FF
Right Log Support Bracket
15