Table of Contents
Advertisement
Using special recording modes (continued)
Loop recording (LOOP REC)
·
1st card
2nd card
Before
starting loop
recording
Recording start
First loop
recording
Second loop
recording
Recording will be made on the areas with no
recording consecutively (A, B, then C). When all
areas on all cards are recorded, new recording
(C) will be made by overwriting the area A.
Check that the SYSTEM SETUP screen is
set up as described on page 43.
Select LOOP in the menu option REC
FUNCTION in the RECORDING SETUP
screen. (Page 138)
Press the START/STOP button.
·
·
·
Use two P2 cards with at least one minute
of remaining recording time.
The mode check screen shows standard
recording time depending on recording
format as remaining P2 card time. When
loop recording is stopped right after
deleting old data, the time of recordings on
the card may be shorter than indicated.
The pre-recording and one-clip recording
functions are not available.
Canceling this function may take some
time. The succeeding operations are not
available until the P2 card access lamp
goes from blinking to steady lighting.
During loop recording, the P2 card access
lamps for all P2 cards used in the recording
light orange or blinks. Note that removing
any of the P2 cards will terminate loop
recording.
Irregularity in the input GENLOCK reference
signal during loop recording may terminate
recording.
Advertisement
Table of Contents
