OSEE BCM-215 Series User Manual page 19

GPI4
GPI5
GPI6
IMD DISPLAY
IMD COLOR
IMD
CHARACTER
IMD PROTOCOL
IMD ID
IMD NAME
IMD(G)
BAUD RATE
LED TALLY
OSD TALLY
MODE
IMD TALLY
MODE
TALLY SOURCE
KEY
KEY INHIBIT
INHIBIT(G)
Note:
*1 - each input would be respectively set.

Dash of select items is the default value.

BCM-215 Series LCD Monitor
Ditto
Ditto
Ditto
ON, OFF
RED, GREEN, YELLOW, WHITE
XXXXXXXXXXXXXXXX
Note: Support 16 characters. Characters including 0x00 and
0x7F (ASCII). Press the ENTER key to input IMD and press UP
or DOWN button to select a character. Press the ENTER key to
select the next character and press the MENU key to exit edit.
LOCAL, TSL3.1, TSL4.0,TSL5.0, IMAGE VIDEO,NETWORK
0 – 255
XXXXXXXXXXXX
Note: Support 16 characters. Characters including 0x00 and
0x7F (ASCII). Press the ENTER key to input IMD and press UP
or DOWN button to select a character. Press the ENTER key to
select the next character and press the MENU key to exit edit.
2400, 4800, 9600, 19200, 38400, 57600, 115200
Note: TSL V3.1 and TSL V4.0 default value is 38400
Video, the items are 9600, 19200, 38400.
ON, OFF
RG, GR, RGY, OFF
Note: Use this setup to select OSD Tally mode, only TALLY
source for standard or standard + IV422, the setup is available.
T1, T2, T1T2, T2T1, T1-, T2-, T1T2-, T2T1-
Note: In Image Video tally control, use this setup to determine
the selection state.
STANDARD, IMAGE VIDEO ,TSL
STANDARD: GPI triggers OSD TALLY
IMAGE VIDEO :IMAGE VIDEO treaty triggers OSD TALLY
TSL:TSL treaty triggers OSD TALLY
ON, OFF
Note: The KEY INHIBIT is ON, KEY INHIBIT is enabled and
press the POWER key, the device would turn on or off.
MENU UP DOWN
， ，
KEYINHIBIT can disaplay.
15
ENTER key can be enable but only the
，
User Manual
In Image
；