Programming The User Code; Programming The Supervisor Code - COMPX StealthLock SL-100 Instruction Manual

Programming the User Code

Use these steps to change your current user code. The factory default code is 0000. User
codes must be 4 to 8 digits in length. To view a video of these steps, go to
www.StealthLock.com Note that the user code can not be changed if the Receiver Latch
has been set to Single Use Mode.
There is a 60 second programming time limit to each step. If you time out or make an
error, programming will end and you will need to restart from step 1.
1. We suggest reading through the instructions prior to beginning programming
2. Press and hold the Receiver Latch learn button until the yellow LED light
begins a one blink pattern, then release
3. Using the Transmitter Pad enter the current user code and press the
Unlock button
4. Wait for green light on Transmitter Pad to turn off then enter the new user
code and press the Lock
5. Wait for green light on Transmitter Pad to turn off then re-enter the new user
code and press the Lock
6. If successful, the green LED light on the Receiver Latch will stay illuminated
for 3 seconds
7. Once the green LED light has turned off, the Receiver Latch will automatically
exit the learn mode
8. Test lock function with new code
9. We recommend writing down your new code in the back of these instructions
and storing in a safe area
StealthLock
button
button to secure code
®
, Keyless Invisible Security 11

Programming the Supervisor Code

Use these steps to change the current supervisor code. The supervisor code allows the
®
owner of the StealthLock to overwrite the user code and change operational modes. The
factory default supervisor code is 071856. It is highly recommended that the
supervisor code be changed. Supervisor codes must be 4 to 8 digits in length. To view
a video of these steps, go to www.stealthlock.com
There is a 60 second programming time limit to each step. If you time out or make an
error, programming will end and you will need to restart from step 1.
1. We suggest reading through instructions prior to beginning programming.
2. Press and hold the Receiver Latch learn button until the yellow LED begins a
two blink pattern
3. Enter the current supervisor code using the Transmitter Pad and press the
Unlock button
4. Wait for green light on the Transmitter Pad to turn off then enter the new
supervisor code and press the Lock
5. Wait for green light on the Transmitter Pad to turn off then re-enter your new
supervisor code and press the Lock
6. If successful, the green LED light on the Receiver Latch will stay illuminated
for 3 seconds
7. Once the green LED light has turned off, the Receiver Latch will automatically
exit the learn mode
8. Test lock function with new code
9. We recommend writing down your new code in the back of these instructions
and storing in a safe area. The supervisor code is not resettable if it has been
forgotten.
StealthLock
.
button
button to secure code
®
, Keyless Invisible Security 12