Using The Smart Start Wizard - D-Link DI-304 User Manual

Isdn/dsl

Hide thumbs Also See for DI-304:

Table of Contents

DI-304ISDN Remote Router

2. If the IP configuration is correct, you will be able to use the Ping diagnostic utility

built in Microsoft Windows to Ping the router. Click Start → Programs → MS-

DOS Prompt. A command mode window will open. Type ping 192.168.0.1 (default

IP of the router) to diagnose the network connectivity. If both hardware and

software are correct, your computer will receive a response from the router as shown

on the next page. If not, verify that the Ethernet cable is connected to the router

properly and the Ethernet port LED on the front panel is lit.

Using the Smart Start Wizard

The Smart Start Wizard will guide you to the Web Configurator or Telnet

Terminal (command-line based management). Also, if the network you currently

installed is not located in the 192.168.0.x IP range, the wizard will find the router

and change the router's default IP address and IP mask to match the current network.

If you are familiar with using a Web browser (Microsoft Internet Explorer, Netscape

Communicator, etc.) or Telnet client software, you may jump directly to the next

section. We suggest you use the most up-to-date version of your Web browser.

Table of Contents