Flymo HT42 Owner's Manual
Flymo chainsaw owner's manual
Hide thumbs
Also See for HT42:
- Operating instructions manual (13 pages) ,
- Manual (11 pages) ,
- Quick manual (9 pages)
Subscribe to Our Youtube Channel
Related Manuals for Flymo HT42
Summary of Contents for Flymo HT42
- Page 1 HT42/420 HT45/450 HT51/510 HT60/600 For all customer enquiries or for replacement parts, contact:- ☎ ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.uk...
-
Page 2: Carton Contents
Switch levers IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Electrolux Outdoor Products Customer Service Department direct Telephone : 01325 300303 Fax : 01325 318193 If not used properly this Hedgetrimmer can be dangerous! This Hedgetrimmer can cause serious injury to the operator and others, the warnings and safety instructions must be fol- lowed to ensure reasonable safety and efficiency in using this Hedgetrimmer. - Page 3 General 1. Never allow children or people unfamiliar with these instructions to use the Hedgetrimmer. Local regulations may restrict the age of the operator. 2. Only use the Hedgetrimmer in the manner and for the functions described in these instructions. 3.
- Page 4 CABLES IMPORTANT • Use only 1.00mm size cable up to 40 metres length maximum. Maximum rating : 1.00mm size cable, 10 amps 250 volts AC. • YOUR HEDGETRIMMER IS SUPPLIED WITH CABLE WIRED DIRECTLY INTO THE PRODUCT. 1. Mains Cables and Extension Cables are avail- able from your local Electrolux Outdoor Products Approved Service Centre.
-
Page 5: Starting And Stopping
Before starting your Hedgetrimmer. 1. Form a loop in mains cable and push the loop through the hole in the handle as illustrated in Fig. B. 2. To secure, position the loop over the hook and pull back as illustrated in Fig. C. 3. -
Page 6: Caring For Your Hedgetrimmer
Caring for your Hedgetrimmer Cleaning (J) 1. Using a soft brush - remove debris from all air intakes and cutting blade. 2. Wipe over surface of your hedgetrimmer with a dry cloth. • IMPORTANT Never use water for cleaning your hed- getrimmer. -
Page 7: Fault Finding Hints
Fails to Operate 1. Is the Power Turned On? 2. Check the fuse in the plug, if blown replace. 3. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Cutting blade stops under load 1. -
Page 8: Service Recommendations
81/1051/EEC as a guide. The maximum A- weighted sound pressure level recorded at operator position under free field semi ane- choic chamber conditions was :- Type... HT42/HT420 HT45/HT450 HT51/HT510 HT60/HT600 Blade Length... 42cm Guaranteed sound power level.. 101 dB (A) Measured Sound Power Level...98 dB (A) Level...
Need help?
Do you have a question about the HT42 and is the answer not in the manual?
Questions and answers