Table of Contents
Advertisement
F
IREPLACE
P
1
ART
Remove front glass door by removing the cardboard fillers at the top and lifting up and away from the
appliance.
Install the handles onto the door using screws from the handle package.
Keep front glass door off of the appliance until installation of Configuration Kit (Part 2) and Control Kit
(Part 3) are completed.
Remove carton containing logs. Retain for later installation.
Remove and dispose of the cardboard support for log carton.
Remove burner pan be removing two (2) screws. Replace screws in holes for later use.
Remove the hearth pan that burner was secured to by lifting it up and off of its four (4) locating pins.
P
2
ART
The appliance is now ready for one of the following configuration kits:
6BK
6CK
6IK
6PNK
6SK
Complete installation instructions are included with each kit.
P
3
ART
After installing the Configuration Kit (Part 2), the appliance is ready for one of the following control
kits:
6CN
6CLP
6CEN
Complete installation instructions are included with each kit.
Once your Configuration Kit and Control Kit have been installed, install the hearth pan by positioning it
down onto the four (4) locating pins, making sure the access panel is positioned over the controls.
The burner may now be installed onto the hearth pan. This is done by positioning the large opening in
the burner, over the pilot protruding up from the control panel. Lower the burner around the pilot down
onto the firebox bottom.
Looking through the large opening in the burner pan, positon the burner tube with air shutter onto the
orifice mounted on the control panel.
The burner may now be secured at both ends with screws removed earlier.
Proceed with Installation.
C
ONFIGERATION
Bay Kit
Corner Kit (Does left or right side open.)
Island Kit
Peninsula Kit
See-Thru Kit
Control Kit Natural Gas Standing Pilot
Control Kit Propane/LP Gas Standing Pilot
Control Kit Natural Gas Electronic Ignition
I
NSTALLATION
6
53D9019. Rev 3 11/07
Hide quick links:
Advertisement
Table of Contents
