Monessen Hearth B-Vent Specialty Gas Fireplace System DESIGNER SERIES Installation And Operation Manual page 19

O
PERATING
F U
OR
WARNING:
A. A.
THIS APPLIANCE HAS A PILOT WHICH MUST BE LIT BY THIS APPLIANCE HAS A PILOT WHICH MUST BE LIT BY
HAND WHILE FOLLOWING THESE INSTRUCTIONS EXACTLY. HAND WHILE FOLLOWING THESE INSTRUCTIONS EXACTLY.
BEFORE LIGHTING SMELL ALL AROUND THE APPLIANCE BEFORE LIGHTING SMELL ALL AROUND THE APPLIANCE
B. B.
AREA FOR GAS AND NEXT TO THE FLOOR BECAUSE AREA FOR GAS AND NEXT TO THE FLOOR BECAUSE
SOME GAS IS HEAVIER THAN AIR AND WILL SETTLE ON SOME GAS IS HEAVIER THAN AIR AND WILL SETTLE ON
THE FLOOR.
WHAT TO DO IF YOU SMELL GAS
DO NOT TRY TO LIGHT ANY APPLIANCE.
DO NOT TOUCH ANY ELECTRIC SWITCH; DO NOT
USE ANY PHONE IN YOUR BUILDING.
IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A
NEIGHBOR'S PHONE. FOLLOW THE GAS SUPPLIER'S
INSTRUCTIONS.
WHEN LIGHTING AND RELIGHTING, THE GAS KNOB CANNOT WHEN LIGHTING AND RELIGHTING, THE GAS KNOB CANNOT
BE TURNED FROM PILOT TO OFF UNLESS THE KNOB IS BE TURNED FROM PILOT TO OFF UNLESS THE KNOB IS
DEPRESSED.
1. STOP! READ THE SAFETY INFORMATION ON THE FIRST 1. STOP! READ THE SAFETY INFORMATION ON THE FIRST
LABEL.
2. TURN OFF ALL ELECTRICAL POWER TO THE APPLIANCE. 2. TURN OFF ALL ELECTRICAL POWER TO THE APPLIANCE.
3. TURN GAS KNOB CLOCKWISE
4. WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS. THEN 4. WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS. THEN
SMELL FOR GAS, INCLUDING NEAR THE FLOOR. IF YOU SMELL FOR GAS, INCLUDING NEAR THE FLOOR. IF YOU
SMELL GAS, STOP! FOLLOW "B" IN THE SAFETY INFOR- SMELL GAS, STOP! FOLLOW "B" IN THE SAFETY INFOR-
MATION ON THE FIRST LABEL. IF YOU DON'T SMELL MATION ON THE FIRST LABEL. IF YOU DON'T SMELL
GAS GO TO THE NEXT STEP.
1. TURN OFF ALL ELECTRICAL POWER TO THE APPLIANCE 1. TURN OFF ALL ELECTRICAL POWER TO THE APPLIANCE
IF SERVICE IS TO BE PERFORMED.
I
NSTRUCTIONS
6CN
NITS WITH
FOR YOUR SAFETY READ BEFORE LIGHTING
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
LIGHTING INSTRUCTIONS
TO OFF.
GAS KNOB "OFF" GAS KNOB "OFF"
TO TURN OFF GAS TO APPLIANCE
6CLP C
AND ONTROLS
IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL
THE FIRE DEPARTMENT.
C. C. USE ONLY YOUR HAND TO PUSH IN OR TURN THE GAS USE ONLY YOUR HAND TO PUSH IN OR TURN THE GAS
CONTROL KNOB. NEVER USE TOOLS. IF THE KNOB WILL CONTROL KNOB. NEVER USE TOOLS. IF THE KNOB WILL
NOT PUSH IN OR TURN BY HAND, DO NOT TRY TO REPAIR NOT PUSH IN OR TURN BY HAND, DO NOT TRY TO REPAIR
IT. CALL A QUALIFIED SERVICE TECHNICIAN. FORCE OR IT. CALL A QUALIFIED SERVICE TECHNICIAN. FORCE OR
ATTEMPTED REPAIR MAY RESULT IN A FIRE OR EXPLOSION.
D. D. DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN
UNDER WATER. IMMEDIATELY CALL A QUALIFIED SERVICE
TECHNICIAN TO INSPECT THE APPLIANCE AND REPLACE TECHNICIAN TO INSPECT THE APPLIANCE AND REPLACE
ANY PART OF THE CONTROL SYSTEM AND ANY GAS ANY PART OF THE CONTROL SYSTEM AND ANY GAS
CONTROL WHICH HAS BEEN UNDER WATER.
5. IF APPLIANCE IS EQUIPPED WITH HI-LO ADJUSTMENT
VALVE TURN COUNTERCLOCKWISE VALVE TURN COUNTERCLOCKWISE
6. FIND PILOT LOCATED IN FRONT OF THE MIDDLE LOG. 6. FIND PILOT LOCATED IN FRONT OF THE MIDDLE LOG.
PIEZO ELECTRODE PIEZO ELECTRODE
THERMOCOUPLE THERMOCOUPLE
7. TURN GAS KNOB COUNTERCLOCKWISE 7. TURN GAS KNOB COUNTERCLOCKWISE
8. DEPRESS AND HOLD GAS KNOB WHILE LIGHTING THE 8. DEPRESS AND HOLD GAS KNOB WHILE LIGHTING THE
PILOT WITH THE PUSH BUTTON IGNITOR. KEEP KNOB PILOT WITH THE PUSH BUTTON IGNITOR. KEEP KNOB
FULLY DEPRESSED FOR ONE MINUTE, THEN RELEASE. FULLY DEPRESSED FOR ONE MINUTE, THEN RELEASE.
IF PILOT DOES NOT CONTINUE TO BURN REPEAT STEPS IF PILOT DOES NOT CONTINUE TO BURN REPEAT STEPS
3 THRU 7.
9. WITH PILOT LIT TURN GAS KNOB COUNTERCLOCKWISE
TO ON.
10. IF EQUIPPED WITH REMOTE ON-OFF SWITCH MAIN 10. IF EQUIPPED WITH REMOTE ON-OFF SWITCH MAIN
BURNER MAY NOT COME ON WHEN YOU TURN THE BURNER MAY NOT COME ON WHEN YOU TURN THE
VALVE TO ON OR HIGH. REMOTE SWITCH MUST BE IN VALVE TO ON OR HIGH. REMOTE SWITCH MUST BE IN
THE ON POSITION TO IGNITE BURNER.
11. TURN ON ALL ELECTRICAL POWER TO THE APPLIANCE. 11. TURN ON ALL ELECTRICAL POWER TO THE APPLIANCE.
2. PUSH IN GAS CONTROL KNOB SLIGHTLY AND TURN 2. PUSH IN GAS CONTROL KNOB SLIGHTLY AND TURN
CLOCKWISE
I
NSTALLED
TO HIGH. TO HIGH.
PILOT PILOT
TO PILOT. TO PILOT.
TO OFF. DO NOT FORCE.
53D9019. Rev 3 11/07
18
GENERATOR GENERATOR
068058 068058