Inlet Hose Connection - Daewoo DWDHQ1221 Instruction Manual

INLET HOSE CONNECTION

The washer should be connected to the water mains using new hose sets, old hose sets should
not be reused.
If in using only one water tap or in case of only one water inlet valve, connect the inlet hose to the
cold water inlet valve.
Note: Be careful not to confuse hot water inlet and cold water inlet if your model has a dual feed
For Ordinary Tap
1 Pull down the collar of
the inlet hose to separate
it from the water tap
adapter.
4 Remove the tape, and
screw connector B into
connector A tightly.
Connector B
Connector A
For Screw-Shaped Tap
1 Connect the inlet hose to
the water tap by screwing
the connector tightly.
Rubber
Connector
Packing
Hose Connector
2 Loosen the four screws
properly in fitting into
water tap.
5 Connect the inlet hose to
the water tap adapter by
pulling down the collar of
the hose end.
2 Connect the connector-
inlet supplied if
necessary.
Connector
inlet
Rubber
Connector
Packing
Hose Connector
6
3 Fit the water tap adapter
into the water tap and
tighten the four screws
evenly while pushing up
the adapter so that the
rubber packing can
attach to the water tap
tightly.
TAPE
6 Connect the inlet hose
adapter of the hose to the
water inlet of the washing
machine by turning it
clockwise to be fixed
tightly.
• Please check the rubber
packing inside the inlet hose
adapter of the hose.
3 Insert the inlet hose
adapter into the water
inlet of a washing
machine and turn it to be
fixed. .
* Check the packing in the inlet