Table of Contents
Advertisement
HOW TO CLEAN THE FILTER
Cleaning the water inlet filter
• Clean the filter if water leaks from the water inlet.
1 Pull the power
plug out before
cleaning it.
Cleaning the drain filter
• This drain filter is used to screen any foreign materials such as threads, coins, pins, buttons etc..
• If the drain filter is not cleaned regularly (every 10 or or so uses), drain problem could be caused.
CAUTION : Be careful when draining if the water is hot.
1. Open the lower cover(1) by
using a coin. Remove the cap
hose(2) to pull out the hose.
100
Cleaning the detergent case
*After a while detergent and fabric softeners leave a deposit in the case;
- It should be cleaned from time to time with a jet of running water.
- If necessary it can be removed completely from the machine by pressing the catch downwards
and by pulling it out.
- To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
* Detergent can also accumulate inside the housing which should be
cleaned occasionally with a brush.
* Once you have finished cleaning, replace the case and run a rinse
cycle without laundry.
2 Turn off the water
supply to the
washer and
separate the inlet
hose.
2. Unplug the cap hose(2),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor.
When water does not flow any
more, turn the pump filter(3)
open to the left.
1
2
27
3 Pull the inlet filter
out.
3. Remove any foreign material
from the pump filter(3). After
cleaning, turn the pump filter
clockwise and insert the cap
hose(2) to the original place.
Close the lower cover.
3
4 Remove the dirt
from the inlet filter
with a brush.
3
2
Advertisement
Table of Contents
