Blade Maintenance; Maintenance And Storage - Qualcast MEH29 Instruction Manual

Maintenance

Blade Maintenance

14
14
Always handle the plastic blades with care, sharp edges could cause injury. Use gloves.
Plastic blades will wear over time or may break if they hit a solid object. Always replace blades in pairs
when worn or broken.
Carry out the following steps to change the plastic blades:
• Disconnect from the mains electricity supply and wait until the cutting head
rotating.
• Turn the mower over and rest it carefully on its side.
• Push the plastic blade
form cutting head
• If a plastic blade
immediately. Always replace blades in pairs.
• Fit new plastic blades into the slots
(Fig.15)
Note! Plastic blades must be replaced in pairs to retain balance. Two plastic cutters of the same type
should be fitted.
IMPORTANT! Ensure plastic cutters are correctly located. Never fit a metal bar balde to this product.
If the blade has broken, it will be difficult to take it off by hand, or even may hurt your fingers, so it is
necessary to wear gloves or other protective equipment to prevent harming your fingers.

Maintenance and Storage

• Replace plastic blades, bolts, nuts or screws, whenever necessary.
• Ask a technical servicing dealer to clean air filter thoroughly and carry out any other service or
repairs required.
• Store in a dry place, out of reach of children.
18
15
towards centre of cutting head
15
has broken during operation remove both blades and replace them
15
16
Customer Helpline 08456 400 800
15
. (Fig.14) Lift the plastic blade away
13
at each side of the cutting head and pull into place.
16
has stopped
13