Monte Carlo Fan Company 5CQM52XX-L Series Owner's Manual And Installation Manual page 5

Installation Instruction (Flushmount)

Remove canopy cover by turning counterclockwise. There are 6 holes

on the bottom of the canopy, 3 of them are larger. (Fig. 5)

Thread lead wires and safety cable through canopy. Place canopy over

yoke, aligning larger holes in canopy with the 3 existing screws on top

of motor housing. Install 3 screws and 3 lock washers (these screws

and lock washers are located in the hardware pack) into the remaining

holes. Tighten all screws securely. (Fig. 5-1)

To prepare the fan for wiring, hang fan onto mounting bracket by

sliding the canopy over the mounting bracket hook (Use one of

non-slotted holes on the rim of the canopy). (Fig. 5-2)

Safety Cable Installation

For Canadian installation and for USA fan and light kit combinations

over 35 lbs, in both ﬂush and downrod modes the safety cable must

be installed into the house structure beams using 3" lag screws,

washers and lock washers provided. Make sure that when the safety

cable is fully extended the lead wires are longer than the cable and no

stress is placed on the lead wires. (Fig. 6)

Note

: If Installing The Secondary Support Safety Cable in the U.S., Do Not

Remove Knockouts In The Outlet Box.

Canopy ring

yoke

Lag screw

Safety cable

Washer

Lock washer

Fig. 5

Canopy cover

Screws

Canopy

Lead wires and

Safety cable

Fig. 5-1

Canopy

Hook

Fig. 5-2

SAFETY CABLE INSTALLATION

Fig. 6

4/25/2015

Table of Contents