Monte Carlo Fan Company 5CQM52XX-L Series Owner's Manual And Installation Manual page 4

Installation Instruction (Downrod Mount)
Partially loosen downrod set screws from yoke at top of motor
assembly.
Remove keeper pin and cross pin from yoke, and save for later use.
Place downrod over canopy , canopy ring and yoke cover. Thread lead
wires and safety cable from motor assembly through downrod.
Slip downrod into motor housing yoke, aligning holes and install cross
pin and keeper pin.
Insert cross pin through yoke and downrod until point appears on the
other side, and insert keeper pin on cross pin.
Pull the downrod up tight against the cross pin, and then evenly tighten
the downrod set screws on motor housing yoke. (Fig. 3)
Warning: Cross pin and keeper pin must be installed securely, failure
to install them will result in serious injury.
Install 4 x 25 watt candelabra base bulbs (25W Max), Bulbs included.
(Fig. 3-1)
Install ball end of downrod into mounting bracket opening. Align
(engage) slot on ball with tab on mounting bracket.
Warning: Failure to align slot on ball with tab may result in serious
injury. (Fig. 4)
© 2015 Monte Carlo Fan Company
Canopy
Canopy ring
Yoke cover
Lead wires and
Safety cable
Cross pin
4
Downrod
Set screw
Yoke
Motor assembly
Bulb
Keeper pin
Fig. 3
Fig. 3-1
Tab
Slot
Fig. 4
4/25/2015