Marcelling - Jacobsen Fairway 305 Turbo Safety, Operating And Maintenance Instructions

10 TROUBLESHOOTING
10.2.3

Marcelling

NOTE: Arrow indicates direction of travel.
Probable Cause
Mowing (ground) speed is too fast.
HOC (height-of-cut) setting is too low
for turf conditions.
Cutting reel diameter is worn.
JACOBSEN FAIRWAY 305 Series CG2
SAFETY AND OPERATION & MAINTENANCE MANUAL
Marcelling, like washboarding, is a cyclical pattern of
varying cutting heights, resulting in a wave-like cut
appearance. In most cases, the wave tip-to-tip
distance is 2 in. (5 cm) or less.
Remedy
Reduce mowing (ground) speed.
Check/adjust HOC to turf conditions.
Check cutting reel diameter and replace if worn.
en-53