Speed Limiter; Rear Wheel Toe-In; Steering Shaft; Alternator - Jacobsen Fairway 305 Turbo Safety, Operating And Maintenance Instructions

9 ADJUTMENTS
9.1

SPEED LIMITER

The transport and mow speeds are factory set and
should not need altering.
9.2

REAR WHEEL TOE-IN

The rear wheels should toe in 3.2mm(1/8") from the
front to the back of the wheel. (Fig.18)
1. Loosen locknuts D at rosejoints inside each
of the rear wheels.
2. For each wheel, rotate tie rod C until the
toe-in is correct.
3. Tighten locknuts D.
9.3

STEERING SHAFT

Casting B should just contact pin A on both sides.
(Fig.18)
1. Loosen nut F.
2. Verify steering balance by rotating steering
shaft G in its cylinder to produce full steering
right and left.
3. Tighten nut F.
9.4

ALTERNATOR

The fan belt is adjusted so that it can be deflected
5mm (0.2in) with a force of 5 kg (11 lbs) applied
midway between the crankshaft and alternator pulley.
(Fig.19) To adjust:
1. Loosen alternator bolts A.
2. Move the alternator to tighten or loosen fan
belt.
3. Tighten bolts A.
en-40
JACOBSEN FAIRWAY 305 Series CG2
SAFETY AND OPERATION & MAINTENANCE MANUAL
NOTE: Textron Turf Care cannot be held responsible
for loss of performance or machine damage if these
speeds are adjusted outside the speeds shown in the
machine specification.
Fig.18
Fig.19