Table of Contents
Advertisement
7HFKQLFDO
0DQXDO
Fairway Mower
71105 - 30 Inch, 6 Blade Fairway Mower
71351 - 30 Inch, 10 Blade Fairway Mower
WARNING:If incorrectly used, this machine can cause severe injury. Those who
use and maintain this machine should be trained in its proper use, warned of its
dangers and should read the entire manual before attempting to set up, operate,
adjust or service the machine.
Part No. 366296-Rev D
GB
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Jacobsen Fairway 71105
Summary of Contents for Jacobsen Fairway 71105
- Page 1 7HFKQLFDO 0DQXDO Fairway Mower 71105 - 30 Inch, 6 Blade Fairway Mower 71351 - 30 Inch, 10 Blade Fairway Mower WARNING:If incorrectly used, this machine can cause severe injury. Those who use and maintain this machine should be trained in its proper use, warned of its dangers and should read the entire manual before attempting to set up, operate, adjust or service the machine.
-
Page 2: Table Of Contents
CONTENTS 6 ......ADJUSTMENTS CONTENTS 1 ........CONTENTS General.............. -
Page 3: Safety
SAFETY SAFETY OPERATING SAFETY ______________________________________________________ WARNING EQUIPMENT OPERATED IMPROPERLY OR BY UNTRAINED PERSONNEL CAN BE DANGEROUS. Familiarize yourself with the location and proper use of all controls. Inexperienced operator’s should receive instruction from someone familiar with the equipment before being allowed to operate the machine. 1. -
Page 4: Important Safety Notes
SAFETY IMPORTANT SAFETY NOTES _______________________________________________ This safety alert symbol is used to alert you to potential hazards. DANGER - Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury. WARNING - Indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious injury. -
Page 5: Specifications
SPECIFICATIONS SPECIFICATIONS PRODUCT IDENTIFICATION _________________________________________________ 71105 ......30 Inch, 6 Blade Fairway mower. Always provide the serial number of the unit when ordering 71351 ......30 Inch, 10 Blade Fairway Mower replacement parts or requesting service information. Serial Number ....An identification plate, like the one shown, listing the serial number, is TEXTRON TURF CARE AND SPECIALTY PRODUCTS attached to the right side gear... -
Page 6: Controls
CONTROLS CONTROLS CONTROLS ______________________________________________________________ Clutch Handles Filler Plug Level Plug Bedknife Adjusting Handle CONTROL DESCRIPTIONS__________________________________________________ A. Clutch Handle C. Level plug Used to engage and disengage the clutch. To Used to determine if grease needs to be added to disengage clutch, turn pointers towards front of gear housing. -
Page 7: Operation
OPERATION OPERATION DAILY INSPECTION ________________________________________________________ 1. Perform a visual inspection of the entire unit, look for 2. Make sure all mowers are adjusted to the same signs of wear, loose hardware, and missing or cutting height. damaged components. 3. Check tires for proper inflation. OPERATING PROCEDURES _________________________________________________ CAUTION To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection. -
Page 8: To Drive / Transport
OPERATION TO DRIVE / TRANSPORT____________________________________________________ Read and follow all safety notes contained in this manual CAUTION when driving or transporting tractor. Refer to Section 5.2 for general operating instructions. When operating in To prevent tipping or loss of control, travel at reduced reverse look behind you to ensure you have a clear path. -
Page 9: Adjustments
ADJUSTMENTS ADJUSTMENTS GENERAL ________________________________________________________________ 2. Replace, adjust, worn damaged WARNING components. 3. Long hair, jewelry or loose fitting clothing may get To prevent injury, disengage all drives, engage tangled in moving parts. parking brake, stop engine and remove key from ignition switch before making any adjustments or CAUTION performing maintenance. -
Page 10: Reel Bearing
ADJUSTMENTS REEL BEARING ___________________________________________________________ 1. Remove both bedknife adjusting handles, springs, spaces and screws (D~G - Figure 6A) to allow the bedknife to swing free of reel. 2. Remove right side drive wheel. 3. Remove screws (J) and the right side reel bearing cover (H). -
Page 11: Height Of Cut Adjustment
ADJUSTMENTS HEIGHT OF CUT ADJUSTMENT ______________________________________________ Remove roller bracket bolts (T). Raise or lower brackets NOTE: Be sure bolts on both ends of roller assembly are in corresponding holes. as desired by relocating bolts in the proper hole combination as shown on the chart. Tightne bolts Numbers Listed in parenthesis are millimeters securely after adjustment. -
Page 12: Maintenance
MAINTENANCE MAINTENANCE GENERAL________________________________________________________________ Keep all moving parts properly adjusted and lubri- WARNING cated. Replace worn or damaged parts before operating Before you clean, adjust, or repair this equipment, the machine. disengage all drives, engage parking brake, stop engine and remove key from ignition switch to prevent injuries Keep all fluids at their proper levels. -
Page 13: Care And Cleaning
MAINTENANCE CARE AND CLEANING _____________________________________________________ Wash the tractor and mower after each use. Keep the Repair damaged metal surfaces and use Textron Turf Care equipment clean. And Specialty Products touch-up paint. Wax the equipment for maximum paint protection. Note: Do not wash any portion of the equipment while it is hot. -
Page 14: Lubrication
LUBRICATION LUBRICATION GENERAL LUBRICATION PRACTICES ________________________________________ Lubrication coupled with cleanliness is the most 2. Apply grease with a grease gun and fill slowly until inexpensive preventative maintenance tool. grease begins to seep out. Do not use compressed air guns. 1. Always clean the area around grease fittings before 3. - Page 15 NOTES NOTES...
-
Page 16: Frame Assembly
FAIRWAY MOWER Serial No. All 1.1 Frame Assembly Item Part No. Qty. Description Serial Numbers/Notes 108096 Axle, Main 400406 Screw, 1/2-13 x 1-1/4” Hex Head 446154 Lockwasher, 1/2 Heavy 472203 Plug, 1/4 NPT Square Head Level 472205 Plug, 3/8 NPT Sqare Head Filler 154499 Housing, Left Side Gear Includes Items 8 ~ 10... -
Page 17: Rear Roller
FAIRWAY MOWER Serial No. All 2.1 Rear Roller Item Part No. Qty. Description Serial Numbers/Notes 132506 Steel Roller 500534 • Bearing, Cup and Cone 338647 • Seal, Inner Grease 3005156 • Sleeve, Wear 3003413 • Shaft, Roller 471214 • Grease Fitting, Straight 367029 •... - Page 18 FAIRWAY MOWER Serial No. All 3.1 Drive Clutch Left Side Shown (Right Side Opposite) 3 / 4...
- Page 19 FAIRWAY MOWER Item Part No. Qty. Description Serial Numbers/Notes 153215 Handle, Clutch 241815 Fork, Clutch 3003158 Spring, Left Side Clutch Handle 3003157 Spring, Right Side Clutch Handle 315861 Washer 460026 Cotter Pin, 1/8 x 3/4” 203975 Wheel, Pawl 315867 Pin, Pawl 241810 Pawl 460012...
- Page 20 FAIRWAY MOWER Serial No. All 4.1 Reel and Bedknife 10 Blade Reel...
- Page 21 FAIRWAY MOWER Item Part No. Qty. Description Serial Numbers/Notes 502671 Reel, 6 Blade Used on 71105 502675 Reel, 10 Blade Used on 71351 121768 Bedknife Assembly 325163 • Bedknife 3007308 • Screw, 3/8-24 x 3/4” Flat Head 445684 • Nut, 3/8-24 Marsden 315912 •...
- Page 22 FAIRWAY MOWER Serial No. All 5.1 Drive Wheel Accessories Steel Wheel Semi Pneumatic Wheel Item Part No. Qty. Description Serial Numbers/Notes 70087 18” Steel Wheel Kit Optional Accessory 70089 17” Steel Wheel Kit Optional Accessory 203987 • Rim, 18” Used on 70087 203992 •...
- Page 23 Limited Warranty 1. Warranty Textron Turf Care And Specialty Products (TTCSP) warrants only to the original retail purchaser (“Warrantee”) that this product shall be free from defects in material and workmanship for a period of one year from the date of the first retail purchase.
Need help?
Do you have a question about the Fairway 71105 and is the answer not in the manual?
Questions and answers