Overhead Position - MasterCraft 058-8194-4 Instruction Manual

23
4. Overhead position: This is the most
fig Q
difficult welding position. For this
position, angle A should be maintained
.
at 60 degrees Maintaining this angle
will reduce falling of molten metal into
(fig Q)
the nozzle .
Angle B should be zero degrees so that
the wire is aiming directly into the weld
joint. If excessive dripping of the weld
MC-588194-18
puddle occurs, select a lower heat
setting.
FLUX-CORE WIRE FEED WELDER KIT 058-8194-4