MasterCraft 058-8194-4 Instruction Manual page 32

29
PROBLEM
Inconsistent arc or
wire feed.
Note: For further repair information, please call 1-800-689-9928.
POSSIBLE CAUSES
1. Not enough drive roller pressure.
2. Spool hub tension too tight or
loose.
3. Contact tip worn or wrong size.
4. Rusty or corroded wire.
FLUX-CORE WIRE FEED WELDER KIT 058-8194-4
SOLUTIONS
1. Tighten the drive tension adjustor on wire
feeder.
2. Adjust the wing nut on the spool holder.
3. Replace the contact tip.
4. Replace the wire.